Data & Privacy
AI & Trust
Cybersecurity
Digital Services & Media
CHAPTER I
GENERAL PROVISIONSArticles 1 — 4
CHAPTER II
PROHIBITED AI PRACTICESArticles 5 — 5
CHAPTER III
HIGH-RISK AI SYSTEMSArticles 6 — 49
CHAPTER IV
TRANSPARENCY OBLIGATIONS FOR PROVIDERS AND DEPLOYERS OF CERTAIN AI SYSTEMSArticles 50 — 50
CHAPTER V
GENERAL-PURPOSE AI MODELSArticles 51 — 56
CHAPTER VI
MEASURES IN SUPPORT OF INNOVATIONArticles 57 — 63
CHAPTER VII
GOVERNANCEArticles 64 — 70
CHAPTER VIII
EU DATABASE FOR HIGH-RISK AI SYSTEMSArticles 71 — 71
CHAPTER IX
POST-MARKET MONITORING, INFORMATION SHARING AND MARKET SURVEILLANCEArticles 72 — 94
CHAPTER X
CODES OF CONDUCT AND GUIDELINESArticles 95 — 96
CHAPTER XI
DELEGATION OF POWER AND COMMITTEE PROCEDUREArticles 97 — 98
CHAPTER XII
PENALTIESArticles 99 — 101
CHAPTER XIII
FINAL PROVISIONSArticles 102 — 113
ANNEXES
(i)
(ii)
(iii)
(iv)
When drafting the common specifications, the Commission shall consult the advisory forum referred to in Article 67. The implementing acts referred to in the first subparagraph of this paragraph shall be adopted in accordance with the examination procedure referred to in Article 98(2).
Standardisation should play a key role to provide technical solutions to providers to ensure compliance with this Regulation, in line with the state of the art, to promote innovation as well as competitiveness and growth in the single market. Compliance with harmonised standards as defined in Article 2, point (1)(c), of Regulation (EU) No 1025/2012 of the European Parliament and of the Council , which are normally expected to reflect the state of the art, should be a means for providers to demonstrate conformity with the requirements of this Regulation. A balanced representation of interests involving all relevant stakeholders in the development of standards, in particular SMEs, consumer organisations and environmental and social stakeholders in accordance with Articles 5 and 6 of Regulation (EU) No 1025/2012 should therefore be encouraged. In order to facilitate compliance, the standardisation requests should be issued by the Commission without undue delay. When preparing the standardisation request, the Commission should consult the advisory forum and the Board in order to collect relevant expertise. However, in the absence of relevant references to harmonised standards, the Commission should be able to establish, via implementing acts, and after consultation of the advisory forum, common specifications for certain requirements under this Regulation. The common specification should be an exceptional fall back solution to facilitate the provider’s obligation to comply with the requirements of this Regulation, when the standardisation request has not been accepted by any of the European standardisation organisations, or when the relevant harmonised standards insufficiently address fundamental rights concerns, or when the harmonised standards do not comply with the request, or when there are delays in the adoption of an appropriate harmonised standard. Where such a delay in the adoption of a harmonised standard is due to the technical complexity of that standard, this should be considered by the Commission before contemplating the establishment of common specifications. When developing common specifications, the Commission is encouraged to cooperate with international partners and international standardisation bodies.